This thesis is a contribution to studies in the field of single and two phase flow processes in porous media. It is to be regarded in the context of an upscaling of physical properties: the simulations were performed on a microscopic scale and were compared to measurements on a larger, a so-called continuum scale. The investigated material was a sintered boron silicate glass. Based on the measured pore geometry (with x-ray tomography), a lattice-Boltzmann Navier-Stokes equation solver was used to calculate the velocity field and the hydraulic conductivity. Additionally, the pressure-saturation relation of a primary drainage process was derived from a pore-morphology-based model. For both hydraulic properties, a REV could be defined and the effective values were compared to measured results. The agreement between the simulation and the measurement is not entirely satisfying and the deviations were thoroughly discussed. Surface properties which were not taken into account could be regarded as a major source of error. Further studies required the reconstruction of the measured pore geometry. Different reconstruction algorithms were therefore applied. Similar structures were generated by using a Boolean model and a simulated annealing algorithm using both the Minkowski functionals and the interception length density distribution. The similarity refers to comparable simulated hydraulic properties.
In der vorliegenden Arbeit wurde das konformative Verhalten von chiralen Rhodium-Bisphosphan-Komplexen des Typs HOCH(CH2PR2)(CH2PR'2)Rh(I)C8H12 mit molekularmechanischen Methoden untersucht. Dazu wurde ein Kraftfeld für diese reaktiven Präkatalysatoren mit einem Gentischen Algorithmus auf der Basis von elf Festkörperstrukturen entwickelt. Mit dieser Methode werden die fehlenden metallinvolvierenden Kraftfeldparameter so angepaßt, daß das zugehörige Kraftfeld möglichst gut Festkörperkonformationen reproduzieren kann. Auf diese Weise konnten zwei Kraftfelder optimiert werden, die die Festkörperstrukturen mit einer mittleren quadratischen Abweichung der Atompositionen zwischen berechneter und beobachteter Konformation von nur 26pm wiedergeben können. In der daran anschließenden Untersuchung des dynamischen Verhaltens dieser reaktiven Präkatalysatoren konnte die konformative Isomerisierung dieser Komplexe ermittelt werden. Die dabei aus dem Modell erhaltenen Reaktionswege und Aktivierungsenthalpien stimmen in allen Teilen und insbesondere im Quantitativen außerordentlich gut mit den experimentellen Daten überein, die durch eine vollständige NMR-Analyse dieser Verbindungen in Lösung unabhängig gewonnen werden konnte.